Sphinxter
Says What?
Looking good!
Cheers for the clarification chief.'MWeston' said:Yeah. that stiff, basically unusable keymat is pretty unforgiving inside the case. The PCB should line up with the top of the SD card slot holes but it sits low and you can see the board edge a bit through the slot opening so that right there creates a gap in the two halves. More proof of this can be seen with the nubs that are sitting a bit low and that is because the keymat keeps the board from getting close enough to the top plastic (and sitting flush on its mounting pegs).
It's all another step in the right direction. I'm quite impressed with how well the light pipes work and concentrate the light into nice little rectangles but still keep that slick continuous feature flush with the hinge.
Soft rubber underneath, topped off with hard rubber like certain cell phone ones. With the printed characters in the middle so they don't get worn off'Megatog615' said:I don't know if it's been confirmed or not but will the keymat have plastic keys or just hard rubber? It would be nice to have little keys like this baby.
CODE'Megatog615' said:I don't know if it's been confirmed or not but will the keymat have plastic keys or just hard rubber? It would be nice to have little keys like this baby.
'Tripmonkey_uk' said:They have shown how easy it is to alter the font size in a couple of the videos, so I wouldn't worry too much about it'Alpha2' said:.. though I dont see how anyone is reading those tiny fonts!
Yeah I know about the font size slider but I was just remarking that so few videos have shown the font increased to readable sizes since then.
'Alpha2' said:'Tripmonkey_uk' said:They have shown how easy it is to alter the font size in a couple of the videos, so I wouldn't worry too much about it'Alpha2' said:.. though I dont see how anyone is reading those tiny fonts!
Yeah I know about the font size slider but I was just remarking that so few videos have shown the font increased to readable sizes since then.
Don't worry, I'm currently working on a finger-friendly theme
Not only Engadget but also the majority of the comments from readers were quite positive. Reaffirming my choice to get a 1st batch model.'j.pickens' said:Yeah,
Somebody at Engadget likes the Pandora.
That video screams out for the usual sarcastic flogging, but they actually presented it pretty straight.
Now if we could just get MWeston to turn off the autofocus we might get somewhere.
I think wires are crossed here, the 'problems' some are referring to, I think, are in the official Blog post:'Vorporeal' said:Some clarifications for people who have been skimming too much:
THERE ARE NO CASE _PROBLEMS_. The reason why the case isn't closing correctly is that the keymat is very stiff, and is not giving the board the wiggle-room needed to sit correctly in the case.