carlgeorge
Active Member
Just a thought I had earlier when I was playing DrMD in the bath, along the lines of I hope I don't drop this.
I want to fit a wrist strap (perhaps from a camera) to the gp32_console , but I can't see anywhere to fit it. I am thinking of lasering a bracket out of some stainless steel to make a little hoop that the strap can be attached to and then fitting the hoop into the case to the right of the EXT port.
Anyone tried anything similar? The bracket would look sort of like a 'T' with a hole at the bottom.
Perhaps with the top part folded back 90deg. I would obviously need to file a little bit of material from the case on the join of the two halves, perhaps use a bit of silicon sealant to prevent rattling.
BTW I was using batteries in the bath not a mains adaptor (that'd be stupid!)
EDIT! tried drawing in ascii but the spaced aren't the same as when editting.
I want to fit a wrist strap (perhaps from a camera) to the gp32_console , but I can't see anywhere to fit it. I am thinking of lasering a bracket out of some stainless steel to make a little hoop that the strap can be attached to and then fitting the hoop into the case to the right of the EXT port.
Anyone tried anything similar? The bracket would look sort of like a 'T' with a hole at the bottom.
Perhaps with the top part folded back 90deg. I would obviously need to file a little bit of material from the case on the join of the two halves, perhaps use a bit of silicon sealant to prevent rattling.
BTW I was using batteries in the bath not a mains adaptor (that'd be stupid!)
EDIT! tried drawing in ascii but the spaced aren't the same as when editting.