I was just wondering if there is any more information ED or Craigix can give us about the moulds. It seems like it's taken a lot longer than the 35 days it should originally take and problems with shrinkage would surely have happened earlier during the process if they had been working on it for the length of time they have. Are there any problems with the company, like with communication, lower priority under other customers etc.? I think Craig said that this was the company that worked on the GP2X case so they've been worked with before. Would just like to know a bit more about where we are with this because everything else seems to be ready. Would be great if someone could let us know more about the dealings with this company and maybe reasons why it seems to be taking longer than it was estimated. I'm fine with delays but i think sometimes lately speculation has been causing a bit of conflict on the boards. It's a difficult job knowing what information to share but if we understood more about the delays that are caused then that might help.