Hello ! I've literally just received my pyra
and apart from going through the setup procedure the first thing I decided to (after doing that) was to give the pyra a charge; the battery was getting a bit low on just 27%
I used a normal usb charger similar to this one and the first time I tried to chage the pyra the charger was saying that the current draw was around 2.7A - ! I immediately disconnected the pyra apon seeing this.
A bit worrying though since the port I'm using (the micro usb3/otg port) only supports up to 2.5A . I tried it again later on and it is now drawing around 1.7A . The battery does seem to be charging however.
I'm not sure why the pyra was trying to draw 2.7A - does that mean my pyra could already now be fried?
ljones
I used a normal usb charger similar to this one and the first time I tried to chage the pyra the charger was saying that the current draw was around 2.7A - ! I immediately disconnected the pyra apon seeing this.
A bit worrying though since the port I'm using (the micro usb3/otg port) only supports up to 2.5A . I tried it again later on and it is now drawing around 1.7A . The battery does seem to be charging however.
I'm not sure why the pyra was trying to draw 2.7A - does that mean my pyra could already now be fried?
ljones