Last edited by a moderator:
Replacement Joystick Caps Available
- Thread starter DaveC
- Start date
bbegin
Still Fresh
I would love to get one too when your next batch will be ready! 
I have a tendancy to sweat when I play games, particularly my hands... :unsure: Your cap would be more than welcome for me.
Benoit
I have a tendancy to sweat when I play games, particularly my hands... :unsure: Your cap would be more than welcome for me.
Benoit
yaustar
UK GP32 & GP2X Owner
I'd probably like one too but I'm not sure if it would fit. My stick isn't centered over the hole. It's like 1mm down from the center
I wonder why they put that stupid raised edge there anyway? If it wasn't there you could put the cap closer to the casing. Decrease the long throw of the stick a bit.
Had the same problem ended up sanding down the underneath of the cap so I could actually go left :/
Last edited by a moderator:
cakey
Still Fresh
You got my payment right DaveC?
Yeah I sent it out already.
Last edited by a moderator:
daclassicgamingmaster
It Is Your Birthday.
I was in skool when you made this topic, and by the ime I checked they were all called for When you have more made up, im definitly buying one. I too am awaiting feedback, but I'm sure they kick ass
benniboi
Still Fresh
Yeah, I'd be interested in one too. Let me know when you have some more available.
I'd probably like one too but I'm not sure if it would fit. My stick isn't centered over the hole. It's like 1mm down from the center
I wonder why they put that stupid raised edge there anyway? If it wasn't there you could put the cap closer to the casing. Decrease the long throw of the stick a bit.
I have a cap where the hole is drilled slightly off center. This would work good for you because you can turn the cap so the narrower wall of the stick is near where the other one hits. This would certainly clear. If you are interested let me know, Thanks.
Last edited by a moderator:
Yeah they should be getting them soon. The mails must be slow, I sent out the first ones Wednesday...
Last edited by a moderator:
whiskthecat
whiskthecat
IN your sig the joystick cap has ridges where your thumb goes but in you original pics there are no ridges. Which one are you selling? B)
The first three didn't have ridges. I added those in later as I had the idea. From now on they will have the ridges like the picture. It is a small modification to the new batch but both seem to handle the same.
Last edited by a moderator:
remowilliams
Member
- Joined
- Dec 17, 2005
- Messages
- 273
I got mine. It feels good on the thumb and is very well made. That Nylatron is strong stuff, you'd break the GP2X before the cap.
My GP2X casing is a bit offcenter on the stick so I'll have to do a little trimming though.
Last edited by a moderator:
silentalarm
Still Fresh
Payment has been sent
Jarska333
What do you want?
Just pull it. With Force™.
Last edited by a moderator:
Sometimes the hole in the cap is very slightly off center too. Try to rotate the cap 1/4 turn or so, it may then clear. I will make the stem a slight bit smaller in future ones. I don't want to make too thin for strength reasons though. If you do have to trim I would suggest filing a flat spot on the side of the cap stem that touches and not triming the length. If you trim the length you will weaken the cap as it will only be pressed over the flat on the shaft and not the round part. It may then fall off. Glad you like it.
Last edited by a moderator:
Yes I do take paypal. I am out of stock at the moment though
I should have more made tomorrow.
Last edited by a moderator:
