Nand Memory...


problem is... once a week or so... ill just set the 2x down, or move and my unit will reset... when i check... the connection has bent back a little, and so i need to bend it back again... basically... my unit is losing all power for about 1/2 a sec...

thanks

Sounds like you need to bend that battery contact out some more. I dropped mine once and had the same issue, but after my initial pry with a key on the battery contact it never lost power again. Maybe you could get extreme and wedge some electrical tape in the crease of the battery contact to force it to contact the battery better?
 
Last edited by a moderator:
thanks cheezer, i was actually exaggerating a bit to explain my concern-- its only happened once or twice... but it was still bugging me... you think it can take a lot of bending? im actually kinda afraid of bending it back too much cuz im afraid the metal will just get weak, and eventually break off... like when you twist a paper clip too much...

thanks though, glad to know im not alone

d
 
Back
Top