AgvirtheSilent
Still Fresh
- Joined
- Oct 1, 2008
- Messages
- 2
Hey everyone,
I have just received my Pandora and I decided to apply a ZAGG Invisible Shield screen protector (a left over part I had laying around from the PSP Slim full body cover). Some of the application fluid must have gotten into the LCD screen/case when I was flattening out the air bubbles under the screen protector as the LCD no longer turns on. When I tried to boot it up, I got the power LCD but the screen remained black/off and I heard cracking sounds from the LCD, so I pulled the battery for now. From what I understand, the application fluid is composed mostly of water. In the end, I removed the screen protector as it wasn't worth the trouble and didn't fit as well as I would have liked it to (since it was a left over part from the full body cutout, after all). -_-
Any advice on what I should do? (e.g. wait until it dries out, try to disassemble to get at the LCD screen to remove the water, etc.)
I have just received my Pandora and I decided to apply a ZAGG Invisible Shield screen protector (a left over part I had laying around from the PSP Slim full body cover). Some of the application fluid must have gotten into the LCD screen/case when I was flattening out the air bubbles under the screen protector as the LCD no longer turns on. When I tried to boot it up, I got the power LCD but the screen remained black/off and I heard cracking sounds from the LCD, so I pulled the battery for now. From what I understand, the application fluid is composed mostly of water. In the end, I removed the screen protector as it wasn't worth the trouble and didn't fit as well as I would have liked it to (since it was a left over part from the full body cutout, after all). -_-
Any advice on what I should do? (e.g. wait until it dries out, try to disassemble to get at the LCD screen to remove the water, etc.)