Pyra datasheets

[ouzle]

Does anyone have a directory full of datasheets for the various chips used in the Pyra? I've been reading up on a few things but keep having to search for the datasheets. I expect someone has got all these in one place already though.

If not, is it ok if I create a list of datasheet links here or on the wiki?

 

[levi]

Sounds like a good fit either for the wiki or here (in which case I'll probably copy the info to the wiki for posterity). I personally grabbed some info for the GSM chip when that was available and some other bits and pieces, but I don't remember where I found them.

 

[ouzle]

In schematic order (v20190717, see replies below):

1. Nubs (x2)
   • AMS N50P105 - Miniature Joystick Modules
     => contains AMS AS5013 - Hall Effect XY Linear Position Sensor
   • MLX90248ESE-EBA-000-SP - Display Lid Sensor Hall Effect Switch
   • V5.5MLA0603NT - 8 x Transient voltage suppressor varistors on gamepad buttons
2. Buttons
   • Panasonic EVQ-PSD02K - 4 x Tactile Switch for shoulder buttons
   • SN74LVC3G06YZPR - Triple Inverter Buffer/Driver With Open-Drain Outputs for left-bottom shoulder and power reset combo
3. Keypad
   • TCA8418RTW - I2C Controlled Keypad Scan IC With Integrated ESD Protection
4. LEDs and GPIOs
   • IS31FL3199 - I2C (addr=0x64) 9 Channel LED Driver
   • Rohm SMLP34RGB2W - 3 x 4-pin RGB PICOLED(R) for "LED-L", "LED-PWR" and LED-R
   • CDBQR0130L-HF Shottky Diodes - 3 x used to make the red leds of the 3 x RGBs also display the "FAULT 1 / 2" and "CHG-STAT" outputs.
   • TCA6424ARGJ - I2C / SMBus I/O Expander
     NXP PCAL6524HEAZ - I2C-bus / SMBus I/O expander
     for "HDMI-CT-HPD", "HDMI-LS-OE", "EN-USB", "EN-HOST1 / 2", "CHG-INT", "MIC-INT", "EN-MODEM", "SHDN-HS-AMP", "EN-OTG", "FAULT1 / 2", "CHG-STAT"
5. Keyboard Backlight
   • LM3699YFQ LED Lighting Driver - with PWM brightness control connected to an "KEYPAD-BL" of the CPU module
   • LW Q38E-Q1OO-3K6L-1 - 24 x White 0603 size LEDs
6. USB-3.0 OTG
   • BossConn USB3-MICABF-CO02 - USB 3.0 Micro AB Female Connector
   • TPD4EUSB30 - 4-Channel Transient Voltage and ESD Protection for Super-SpeedUSB 3.0 Interface
   • IP4220CZ6,125 - Dual USB 2.0 integrated ESD protection
   • DLP11TB800UL2L - 2 x Common Mode Chokes / Filters 0504 80ohm EMI Suppression Fltr
   • ACM2012-900-2P-T001 - Common Mode Choke / Filter 50V 200mA 680ohms AEC-Q200
7. USB-2.0 Host + eSATA
   • TPS2561ADRC - Dual USB Power IC to control the current to the USB host ports when "EN-HOST" is enabled
   • TPS630701RNMR - 2V to 16V Buck-Boost Converter With 3.6-A Switch Current, powers USB hosts
   • Molex 48393-0003 - USB 3.0 Female Type A Connector
     USB 2.0 data pins connect to "HOST1-D" pins of the CPU module
     USB 3.0 data pins connect to "SATA-RX" and "SATA-TX" pins of the CPU module
   • Assmann AU-Y1006-2-R - USB TYPE-A USB 2.0 Receptacle Connector 4 Position Surface Mount, Right Angle
     USB 2.0 data pins connect to "HOST2-D" pins of the CPU module
   • IP4220CZ6F - Dual USB 2.0 integrated ESD protection
   • TPD4EUSB30 - 4-Channel Transient Voltage and ESD Protection for Super-SpeedUSB 3.0 Interface
     used on eSATA lines
8. Charger / OTG / Power
   • BQ24297RGER - I2C (addr 0x6b) Controlled 3A Single Cell USB Charger With Narrow VDC PowerPath Management and Adjustable Voltage USB OTG
     Looks after "VBUS", "VBATT", "VSYS", and the USB "OTG" voltages.
     Provides a "CHG-STAT" charging status used to make "LED-PWR" red.
     Monitors the "BATTEMP" battery middle pin.
     Sends "CHG-INT" 256-μs pulses to the CPU module to report charger device status and fault.
   • TLV70233DBVR - LDO Voltage Regulator, drops VSYS down to 3V3, but only when CPU Module supplies "1V8" to the LDO's enable input
   • INA231YFFT - I2C (addr 0x4x), Current / power monitor for "VMODEM"
   • TPS22963CYZPT - 5.5V, 3A, 13mΩ On-Resistance Load Switch
     to control "VMODEM" from "EN-MODEM" signal
9. Battery Fuel Gauge
   • BQ27421YZFR-G1D - I2C (addr 0x55) Battery monitor - System-Side ImpedanceTrack™ Fuel Gauge With Integrated Sense Resistor
     Used to measure "VBATT"
   • AVX 009155003201006 - Battery Contacts 3Way .4um Ht=3mm 3A 2.5mm Pitch Rdc Size
10. SD-Slots
    • FPS009-2960-0 - 2 x SD Card and MMC Reader - Push / Push (Reversed Type)
    • Wellco SMSN16-X0-2X00 - SIM and microSD card connector
    • TPS62233DRY - 2 x Switching voltage regulator to provide current limitted 3V0 power to SD cards
11. 3G / 4G Modem (with GPS) + SIM
    • Thales Cinterion Model PLS8-E (European)
      AT command set
      LTE (20,8,3,7,1); 3G (8,3,1); 2G Dual B
      UMTS/HSPA (FDD) 3GPP
      GSM/GPRS/EDGE 3GPP
      GPS/GLONASS solution
      USB interface
    • Antenova A10393 RUBRA - 824 MHz to 2.17 GHz, 50Ω 3G / 4G antenna
    • Molex 73412-0110 - 6GHz, 50Ω Coaxial Connector connector, surface mount U.FL type
    • Murata MM8430-2610RB3 - 3GHz, 50Ω Coaxial Connector, surface mount U.FL type
    • UMG5NTR - NPN Bipolar transistor used for "MODEM-IGNITE" signal.
    • ESDA6V1-5P6 - 4 and 5 line ESD protection in SOT666
12. WLAN & Bluetooth
    • WL1837MODGIMOCT - WiLink™ 8 Dual-Band Industrial Module
      Wifi, Bluetooth and Bluetooth Low-Energy (BLE)
      Dedicated audio processor supporting on-chip SBC encoding + A2DP
13. Charger / Console
    • Molex 105017-001 - Micro-USB B Receptacle, Bottom Mount, Surface Mount, with Solder Tabs
    • FT232RQ - USB to serial UART interface
    • FPF3040UCX - 18V-Rated Dual Input Single Output Power-Source-Selector Switch
      Chooses where to connect USB "VBUS" power lines when "EN-OTG" is set or not.
    • TPS22963CYZPT - Digital power switch to send power from "VSYS" to USB FPG3040UCX when "EN-OTG" is set
14. Sensors
    • Bosch BMG160 - Tri-axial gyroscope
    • Bosch BMC150 - Compass and 6-axis accelerometer
15. Sensors (integrated)
    • Bosch BNO055 - I2C (addr=0x28 / 0x29) - Inertial Measurement Unit
    • Bosch BME280 - I2C (addr=0x76 / 0x77) - Humidity sensor
16. HDMI
    • TPD12S016RKTR - HDMI Companion Chip with I2C Level Shifting Buffer, 12-Channel ESD Protection, and Current-Limit Load Switch
    • Molex 46765-2301 - HDMI Connector, Right-Angle Receptacle, Surface Mount, 0.40mm Pitch Micro
    • DLP11SA900HL2L - Common Mode Chokes / Filters 90Ohm 20% 100MHz
      4x used on HDMI-DATA0 / 1 / 2 and HDMI-CLK lines.
17. Display & Touchscreen
    • BOE BTL507212-W677L - 5" LCD Panel with 720(RGB)×1280 WXGA resolution
    • TI TSC2007 - Resistive touchscreen I2C interface (addr=bus 3:0x48)
    • Hirose FH26-39S-0.3SHW(05) - 39 Position FPC Connector Contacts, Bottom 0.012" (0.30mm) Surface Mount, Right Angle
18. Audio Headset
    • TS3A227ERVAR - Autonomous Audio Accessory Detection and Configuration Switch
      Detects 3-pole or 4-pole audio accessories (headphone / microphone) and configures internal switches to route the signals accordingly.
    • FDV301N - N-channel MOSFET used to generate "PLUGDET" signal when headphone jack is inserted.
    • CUI SJ-43516-SMT-TR - 4-contact, 3.5mm audio jack with tip and ring switches
19. Audio Out
    • Seltech GR1813L025UN8 (discontinued)
    • 50K Dual Potentiometer (not specified)
20. Misc
    • Infineon BGM1034N7 - GPS and GLONASS Front-End Module, a low-noise filter and pre-ampliflier (LNA)
    • Precision Micro 304-106 - 5mm x 7mm vibration motor, 3V @ 37.5mA, 9500rpm, 0.6g amplitude
21. CPU-Module connector
    • Hirose DF40C-100DP-0.4V(51) - 2x Board to Board & Mezzanine Connectors 100P SMT HEADER NO FITTING, NO BOSS

CPU Board

• OMAP5432AAN - "Multimedia Device"
  • Operating conditions
  • Reference guide
• TWL6037 - (i2c addr=0x48,0x49,0x4A) - Power Companion IC (CPU ~1.05V Power, 32KHz clocks, Real Time Clock, boost convertor to generate VBUS when in OTG host mode)
• TWL6040 - (i2c addr=0x4B) - 8-Channel low-power audio coder / decoder ('codec') for portable applications
• USB3503 - USB 2.0 3-port hub
• Samsung DDP DDR3L D-die 4GB 1600MHz

 

[docbroke]

In schamatic (v5.1.3) order:

These are newer, I don't remember from where I downloaded these.

 

[hns]

Great work!
Some comments for completion (if you want to make a Wiki Page) when comparing to the mass production release:
* TCA6424ARGJ has been replaced by pin compatible NXP PCAL6524HEAZ
* RF-connectors are U.FL type Molex 73412-0110 and Murata MM8430-2610RB3
* Speakers are Seltech GR1813L025UN8 (may have been discontinued) or compatible
* TS3A5223RSW and its function has been removed because it can't avoid leakage current into the WWAN module if that is powered off
* 3G/4G Antenna is Antenova A10393 RUBRA

 

[asimov-solensan]

These are the things I love about the project. I remember breaking the LCD coil on pandora, checking the original one a list like this one with same parameters physical format.

 

[levi]

Okay, that took a little more work than I anticipated, but I think I've copied all of the data (plus hns's corrections) into the wiki, all linked from the hardware page. Please check it for correctness and completeness.

 

[ouzle]

The datasheet list is now updated to the v20190717 schematics.

 

[levi]

Could you be a dear and mark the new/updated lines in red or something, so I can see them easily and update the wiki?

 

[ouzle]

Sorry for the confusion darling I forgot to do version tracking there. It looks like you've worked through the list on the wiki now anyway?

 

[levi]

No, all the text I copied to the wiki will have come from that post as it was yesterday, sweetie.

 

[ouzle]

Ok honeybuns, I'll make the updates on the wiki. I'll update the schematics link to the attached zip.