Yesterday, my Pandora had a fall of about 35cm and the display immediately stopped working,
so I guessed, that the LCD-Cable might be loose.
I wanted to open and replug it, but here is the problem:
I see, that there are 5 screws in the back and the three on top were no problem,
the two on the SD-side are hard to turn and just won't come up.
I fear ruining the screws heads trying it over and over again, because they can be turned with force but they just stay the same height
and still attach the two halfs of the shell without any gap.
What should I do?
As far as I can see into it, the screw on the right seems to be ruined already and that may have been the problem from the beginning,
because I have to give it a lot of pressure to stay in the screws head at all and my screws were all extremely tight and deep.
Left one is up now and looking better, but won't fall out and starts to grip again as soon as there is the slightest pressure on the case.
One of the screws from the top looks a bit broken off at the shaft, but this cannot be happened now, because they made no real problems.
Dafuq? I got quite a collection and always use the right bit, but there seem to be no way getting the last screw out,
there is not enough grip in it anymore, cheap metal?
Do I have to part with her again because of this?
I really do not want to drill it out. :/
so I guessed, that the LCD-Cable might be loose.
I wanted to open and replug it, but here is the problem:
I see, that there are 5 screws in the back and the three on top were no problem,
the two on the SD-side are hard to turn and just won't come up.
I fear ruining the screws heads trying it over and over again, because they can be turned with force but they just stay the same height
and still attach the two halfs of the shell without any gap.
What should I do?
As far as I can see into it, the screw on the right seems to be ruined already and that may have been the problem from the beginning,
because I have to give it a lot of pressure to stay in the screws head at all and my screws were all extremely tight and deep.
Left one is up now and looking better, but won't fall out and starts to grip again as soon as there is the slightest pressure on the case.
One of the screws from the top looks a bit broken off at the shaft, but this cannot be happened now, because they made no real problems.
Dafuq? I got quite a collection and always use the right bit, but there seem to be no way getting the last screw out,
there is not enough grip in it anymore, cheap metal?
Do I have to part with her again because of this?
I really do not want to drill it out. :/
Last edited by a moderator: