I downloaded egoboo and put it on my gp2x Firmware 3.0.0.  I ran the primnumber overclock test just now to see how high I could overclock it to to run it.  It got to 5000 something of the 270mhz one, and froze.  I turned it off, and then turned it back on.  When it turned on, it ran the little opening screen, and then it just showed like these rainbow color lines.  I turned it back off and then on again, and it worked fine.  I'm just wondering what that problem was and what this means on how high I should set the CPU for egoboo.  Thanks!
				
			 
	
 
 
		 
 
		 
 
		