Glass Screen Is Too Thick!

[DaveC]

Guys with the FLU have the frame stick out too because of the light guide that is added. So it is not that uncommon. I use special glass in my GP32 that is as thick as the plastic. My frame is perfectly normal but the glass could break easier, but I am careful with it.

 

[CeNTauR2]

I got my screen last week. It was too wide aswell, so I had to
cut about 1 mm of the plastic indentions to make it fit.

Sticks out a little bit. Maybe I will try to find thinner glas,
but if this breaks and scratches your light guide, the unit
would be ruined.

By the way: I tried cleaning the light guide with alcohol
and a Q-tip, leaving marks all over it around the edges
where the alcohol vaporized.

At first I was very pi**ed because the screen looked
awful. So after some experimenting I found, that window
cleaner can perfectly used to clean the light guide
again from waterdrips, alcohol etc.

The only thing I don*t get away anymore is a light
small point of washing petrol I accidently used. I look
dull know.

So, does anyone know how to remove the dull-effect
of petrol from a plastic surface like the light guide?

Thanks
Sebastian

 

[trooper]

@ CeNTauR2

Personally, I wouldn`t muck around with the light guide/diffuser anymore than you already have, Judging by what you`ve already done to it. The next time you fiddle with it maybe the last, As you could end up doing irreversible damage to it.

Trooper

 

[Jr2swiss]

The glass screens should fit inside the grey screen holder, it may be tight however.

 

[spaceboygp32x]

The glass screens should fit inside the grey screen holder, it may be tight however.

​

mines a FLU - my glass screen makes the grey bit pops out about 1.2 mm - it looks good - its tough (and i commute with it) ...

and stops my fingers slipping onto the screen...

In my experience the more you mess the worse it gets... :blink:

sPaCe h34r:

 

[LHC]

My grey bit isn't stuck down any more, and I'm too lazy to stick it back on. :rolleyes: