Solder Points For Flu

[diego]

hi there,

i have a big problem, i opened my gp32 to few minutes ago. while that two cables of my flu lost the contact to the pcb. now i didnt know on which points i have to solder them.
i think the solder point for the black cable is t1, but im not sure. no idea where te red cable was soldered.

thanks in advance

 

[Quiest]

Sorry, I can`t help you cause I only have a non flu GP32.

But you should have used a tutorial, like the one on reloded.com for example, before opening your gp32.

 

[aapje89]

Sorry, I can`t help you cause I only have a non flu GP32.

But you should have used a tutorial, like the one on reloded.com for example, before opening your gp32.

​

A bit too late now

 

[Zorn]

i had this problem too. but a long time ago. sorry i don't know any more where to put on which cable....

 

[diego]

does anyone know a site with a picture from a open flu, maybe i can see where the points are.

sorry, I can`t help you cause I only have a non flu GP32.

But you should have used a tutorial, like the one on reloded.com for example, before opening your gp32.

thanks, next time i use it for sure

 

[diego]

i have written an email to the webmaster of reloded.com and asked him for help.
maybe his answer will help some others too, so i post it here:

Black wire from FLU/light to T7.
Red/Orange wire from FLU/light to either terminal on the switch. Another wire (red?) from the 2nd terminal on the switch, to T1.

That should work, if not, just swap the T1 and T7 wires over, i.e., put black wire (from FLU/light) onto T1, and the red/orange wire (from switch) onto T7.