aTc
Very Active Member
- Joined
- Apr 25, 2009
- Messages
- 253
After the loose shoulder buttons, the lcd bezel not sticking properly, and the snapped screw hole, I found something else not working properly on my pandora.
My right speaker doesn't do anything.
I've been mostly using headphones when doing anything with sound, so I didn't really notice it at first.
Because the speakers are so close together, you hardly notice there's only sound coming from one of them, unless you really try to listen for it.
It's quite obvious when I put my thumb on the left speaker though.
With headphones both channels do work, so it's not a mixer problem.
Yes, I have opened up my pandora to look at the shoulder button problem (I'm not going to lie about that), but I don't think this was caused by that. I haven't made any modifications to anything inside, and I didn't remove board. (Not to mention that I couldn't even see any wires going to the speakers from this side that might have snapped off.. if only, that would make it a lot easier to fix )
A bit late now, but still a thing to add to the checklist after assembling a pandora.
Big question of course is, do I still have warranty to get this fixed/replaced ?
My right speaker doesn't do anything.
I've been mostly using headphones when doing anything with sound, so I didn't really notice it at first.
Because the speakers are so close together, you hardly notice there's only sound coming from one of them, unless you really try to listen for it.
It's quite obvious when I put my thumb on the left speaker though.
With headphones both channels do work, so it's not a mixer problem.
Yes, I have opened up my pandora to look at the shoulder button problem (I'm not going to lie about that), but I don't think this was caused by that. I haven't made any modifications to anything inside, and I didn't remove board. (Not to mention that I couldn't even see any wires going to the speakers from this side that might have snapped off.. if only, that would make it a lot easier to fix )
A bit late now, but still a thing to add to the checklist after assembling a pandora.
Big question of course is, do I still have warranty to get this fixed/replaced ?