Help


karmaKid

Still Fresh
Joined
Nov 1, 2007
Messages
45
Can anyone help?

When I boot my GP2X up without and SD card onboard it runs a full boot sequence, but ends up on a black screen - the GP2X is totally unresponsive.

When I boot with an SD card in it cheerfully boots to Gmenu2X and I can run anything from Gmenu2X, yet when I exit Gmenu I get the back screen again, and the GP2X is completely unresponsive.

I can read the SD card fine via USB, and this is happening with both 1.1 and 4.1 firmwares.....

Help! I'm confused! :blink:
 
We all confuzed too. Turn on the internet connection switch on your gp2x so we can test your device online. :)
 
EvilDragon said:
Sounds like the original gp2xmenu is broken.

What FW do you have?
Well, it stopped working with the firmware version it came with at Xmas, but I upgraded it to 4.1.1. when the fault occurred in the hope that it would sort it, but it didn't.

It is still running 4.1.1
 
Last edited by a moderator:
Try a full reflash of FW 4.0.0 (if it was shipped with that FW) or FW 4.0.2 (if it was shipped with that one).

Do a normal flash, EXCEPT FOR gp2xboot.img. Don't put that one onto the SD Card!

For a normal flash, copy everything onto the card (except the gp2xboot.img, as mentioned above), put it into your gp2x, press and hold START + SELECT while switching it on until "Upgrading Firmware" appears.

This could work. If not, you need to run the NAND Bad Blocks Fixer by Orkie first.
 
Well, ED.... I did all that stuff and now I have almost everything working on Firmware 4.1.1....

BUT I now have no front end (or anywhere else for that matter) touchscreen support!!!

Grrrrr..... anyone got any ideas how I can fix the touchscreen???
 
Well, the 4.1.1 frontend changed a bit about the touchscreen thing.
If you didn't upgrade exactly according to the instructions, this might be what happens.
 
Back
Top