Firmware Gone Bad


adolobe

Still Fresh
Joined
Dec 3, 2003
Messages
96
Age
43
Location
San Diego & Raleigh NC 50/50
I have an old NLU GP32 and I tried to upgrade the firmware, I got the msg that it was done and to restart but after I restarted the red light comes on and the unit does nothing. So Im assuming its bricked.

Does anyone in the USA have the ability to use Jtags and reflash the unit

Also on a side note I have purchased GP32 BLU off ebay but it has the original firmware not euro and I check by holding down select for multi but no go and I want to put the Euro firmware on it. Does anyone know the correct method to do this with out hooking the unit up to the computer as I cant get vista to install any of the drivers.
 
adolobe said:
I have an old NLU GP32 and I tried to upgrade the firmware, I got the msg that it was done and to restart but after I restarted the red light comes on and the unit does nothing. So Im assuming its bricked.
Standard response: Try fresh batteries. If you've already tried that, try a power supply. Note the middle pin is negative!
I'm looking at getting a j-tag but it may still be a while.
 
Last edited by a moderator:
Back
Top