Erk, Nub Problem


Damn, because I'm a 1 nub Pandora order, I guess my only option is to replace it myself. Any ideas on how/where to buy the part? Or is this not possible because they have to be programmed before hand or something? :(

All I can say to all the rest of you is, be careful spinning the nubs!
 
They said they'll sell all the parts in the future. The nubs don't have to be programmed, they peogram themselves, afaik.
 
mali said:
They said they'll sell all the parts in the future. The nubs don't have to be programmed, they peogram themselves, afaik.
AFAIK there's nothing to be programmed in the nubs. The nub controller µCs are on the other side of the PCB (two ATMega8Ls). Dunno how hard it will be to desolder a nub.
 
Last edited by a moderator:
Back
Top