denwebbx85
Still Fresh
- Joined
- Aug 27, 2005
- Messages
- 23
I don't believe this question has been asked. Does anyone know what voltage ac adapter will be required for pluging the Gp2x into the wall.
Ac Adapter Voltage...
- Thread starter denwebbx85
- Start date
slygamer
Active Member
Nothing is known about the requirements for an external power supply yet, as stated in the FAQ.
theoddbot
Certified Guru
slygamer posted on Sep 30 2005 at 12:36 PM said:
I'd hazard a guess at 5V, but wait and see.
Last edited by a moderator:
Vimacs
Don't be evil!
3v, but as usal +-10% should be fine
icurafu
The Hallucinogenic Elf
That's what I heard. The USB Host runs at 3V, but since it needs 5V, then it can not host anything that is not self powered.
Vimacs
Don't be evil!
The gp2x runs at 3v, the uab host power lines are most likely not connected.
second exodous
Advanced Member
Hmm, wouldn't the wall adapter be included? It's not listed anywhere, but I would think it would come with one. Although when the handhelds don't have rechargeable batteries in them I guess they don't supply a AC adapter, i.e. Nintendo and Saga.
Thanx,
Stan
Thanx,
Stan
icurafu
The Hallucinogenic Elf
second exodous posted on Sep 30 2005 at 05:39 PM said:
hmm, from what I understood from the korean chat room conversation, is that the host is connected by default as it is the same connector as the slave.
So it is charged to 3v, even it it is never used. But it is easy to misunderstand each other i guess.
Last edited by a moderator:
Squidge
Certified Guru
GP2X is 3V Center negative. Exactly the same as the GP32.
Power for USB host is not connected.
Power for USB host is not connected.
Winterkid
Active Member
Squidge comes through for us again! Woo!
Alpha2
Heroic Autobot
So it'd basically use whatever adapter you get for the gp32... unfortunatly I never found an adapter I could feel comfortable using on it with some people reporting they burned theirs out by not getting one with just the right settings.
Winterkid
Active Member
The adapter I got for My GP32 was just right.. Multiple settings for voltage (set to 3v), 500 mA, reversible polarity, etc.
Vimacs
Don't be evil!
would be great if the gp2x would have some crossed dioids so we could use both polarities.
weirdocollector
Member
Squidge posted on Sep 30 2005 at 08:52 AM said:
Does the AC adapter need to be stabilized ?
Last edited by a moderator:
Winterkid
Active Member
Check that, the mA rating for my adapter is 600 mA apparently.
Still worx tho.
Still worx tho.
