Giana Sister Don't Work, How To Load .gxb


DaveC

Internal Development
Joined
Mar 4, 2004
Messages
9,208
For some reason when I load the Giana beta all it does is reset the GP32. Also I put some demos with a .gxb extension in the GPMM dir but they don't show on the launcher (.FXB work fine). What did I do wrong?
 
DaveC posted on Mar 10 2004 at 06:24 AM said:
For some reason when I load the Giana beta all it does is reset the GP32. Also I put some demos with a .gxb extension in the GPMM dir but they don't show on the launcher (.FXB work fine). What did I do wrong?
What program do you use to launch Giana? Some of the existing launchers seem to fail to run Giana because the system simply runs out of memory (Giana is compressed so actually it is a lot bigger than the file indicates).
 
Last edited by a moderator:
This does not work with the Euro Firmware, but tried it with pacrom and it worked fine.
 
Worked on New beta bios 1.6.6 (well not sure it's that new!)
Giana's one fxe where'd you get a gxb?
Also works with slubman's launcher!
 
Giana doesn´t work with the european firmware in aquamultifirmware v4. The loading data bar doesn´t appear and the gp32 doesn´t respond.
It does work when launched from 0.15 filemanager and yafm. Loading does take some time but the game runs normally.

I must say I am very impressed by the graphics, the rippling water effect. The parallax effects. And it´s a bit more difficult than the c64´s original which I happen to have installed with frodo on the same card. Nice comparing the two. I prefer the newer incarnation! Great job! :D
 
Hi!

But its not possible to go futher than Level 5 in new Giana Sisters or?

Lord
 
V3X posted on Mar 10 2004 at 06:29 AM said:
u need 2 download gxb loader it can be found in downloads, gp32 utillities :)
I downloaded the GXB loader. but when I run it it starts to load and then just says "error !!!" in the middle of the screen. Any ideas?
 
Last edited by a moderator:
Back
Top