Pandora update

[fantomid]

Hello guys,

When I try to update one Pandora, I got the following error:

"
Starting updater. Press Alt+RightArrow for verbose output..

Can't access SD card, please reinsert and press enter
"

 

On another Pandora, I used the same SD card and the update was fine.
Any idea ?

 

[notaz]

Have you actually tried reinserting and retrying? Maybe it needs full pandora reset?

 

[fantomid]

Have you actually tried reinserting and retrying? Maybe it needs full pandora reset?

With the same SD card and with another SD card, same result.

What do you mean by "full pandora reset"?

 

[notaz]

Basically turning off and back on. Also try removing battery for 5 minutes.

If that doesn't help, go to a shell (alt+left/right) and check if there are any /dev/mmcblk* files, also see if there is anything in dmesg after replugging the card.

 

[fantomid]

Basically turning off and back on. Also try removing battery for 5 minutes.

If that doesn't help, go to a shell (alt+left/right) and check if there are any /dev/mmcblk* files, also see if there is anything in dmesg after replugging the card.

No /dev/mmcblk* files even if after replugging the card

On the second port, the card is quickly discovered.

 

[notaz]

Sounds like card detect pin on left slot is broken.

When it asks to reinsert the card, try inserting it into right slot and pressing enter.

 

[fantomid]

Thanks Notaz.

Update is OK.

I didn't think it was possible to change to the second SD port to continue the update.

Sounds like card detect pin on left slot is broken.

What is the best solution for this point ?

 

[notaz]

I don't know, maybe ED can fix it, but if it's under the BGA chip there is little chance to fix it without special equipment.

 

[fantomid]

I don't know, maybe ED can fix it, but if it's under the BGA chip there is little chance to fix it without special equipment.

OK. I will try to see where is the defect on the Molex SD card holder.

I got failed board, I could use to repair.