Gmenu2x

[Pickle]

Gmenu2x is no longer beta
I finished adding clock and battery support for the wiz version.

The clockspeed is capped at 900 Mhz. The default clock for applications is at 550 Mhz.
It is changeable in all situations by 10 mhz.

Im not confident that the battery monitoring is accurate. I added the wiz's battery device but left the battery levels the same as the gp2x. Im assuming GPH left it the same, which they usually do.

Binary: http://dl.openhandhelds.org/cgi-bin/wiz ... ,0,0,7,124
Source: http://dl.openhandhelds.org/cgi-bin/wiz ... 0,0,46,125

(I will be sending a patch to Ryo, so hopefully this gets into the svn in due time)

 

[rx_shorty]

Nice Pickle!

 

[sbock]

Yeah, thanks Pickle! gp32x.de may be down but the porting goes on...

 

[Mark1970]

It doesn't work for me. That is it runs but is unresponsive. Unzipped the file to the root of my card, autorun enabled and the gmenu2x screen does appear but it is not responsive at all. Touch screen is enabled but way way off calibration wise - touch screen functions properly in other applications.

The indicated speed is 100Mhz so that may be a problem.
Oh and I am running 1.1.0 firmware - that is the culprit no dount. :-(

 

[Munky Flux]

yeah its the same as me i tried running it and the touchscreen was way off calibration and none of the buttons worked...
at the start says 100Mhz and then it knocks up to 550Mhz....

im also running firmware 1.1.0... just wondering which ones you guys are running yours with which works?

 

[Munky Flux]

nvm i found more information on the gp32x forums, reading pickles replies to the same problem with the firmware 1.1.0