Configure Usb Networking

[canvasfly]

Hello

I recently purchased an interface board and would like some help in configuring my gp2x to connect to my network. I've been looking around and haven't found any instructions. I have both a usb netgear wifi adaptor and a linksys usb wired network adaptor.

When I go to the extended settings menu on my GP2x, there is a USB Networking configuration. Am i supposed hardcode an IP Address? Do the network setting currently only allow a connection between my gp2x and my pc (for example using a cross over cable)


thanks

 

[Squidge]

The settings in the menu are for networking your gp2x via usb. It allows telnet/ftp/web etc (both clients and servers).

I've no idea how you go around with setting up a network interface via a BoB and Wifi, presumably you'd need to telnet in to the gp2x and enter the linux commands manually.