tomj
Still Fresh
Help 
I used one of my breakout board cable connectors to try out something now I have soldered it back together so the wires go from the connector to the equivalent pin. like a standard Ethernet cable but I think it might be reversed so it should be wired like a crossover cable. It doesn't work I had to desolder nReset to allow me to even turn it on when the gp2x is plugged in. It isn't solder bridging either as I have been very careful (I even bought and used some heat shrink tubing to avoid problems). Any help would be appreciated I have already soldered this thing twice.
I used one of my breakout board cable connectors to try out something now I have soldered it back together so the wires go from the connector to the equivalent pin. like a standard Ethernet cable but I think it might be reversed so it should be wired like a crossover cable. It doesn't work I had to desolder nReset to allow me to even turn it on when the gp2x is plugged in. It isn't solder bridging either as I have been very careful (I even bought and used some heat shrink tubing to avoid problems). Any help would be appreciated I have already soldered this thing twice.