Aquafish 4.8b

[osy_tnt91]

This is mi problem:
-I installed aquafish 4.8b multifirmware
-I changed 48b.bin into fw.bin
-I replace the firmware
Until that, all goes perfectly but when I reset GP32, it asks me for a password, I put AAAA, but it sais, that´s incorrect.
What can I do if I´m doing all all right??
Bye

 

[Rocketballs]

Are you sure it's a GP32? and not a GBA.

 

[osy_tnt91]

MMMMMMMMMMM, yes, jejeje, what a question <_<

 

[Steve-O]

hhmmm, looks like you put the Passowrd Protector on... Read the Readme, It will tell you the Password

 

[osy_tnt91]

WARNING : you can broke your gp if the flashing fail ! don't take me responsable if that happen.

multi firmware v4.8

it include :
-the european firmware (the second version, it's pclink don't work)
-pacrom 0.31 by pacman
-yafl 0.3 by woogal in the version 4.8a or
-wind-ups 1.0 by karthur in the version 4.8b
-smc recovery


if you want to use a background, put a 320*240*24bpp bitmap file renamed boot.bmp in the gp:\ directory.

if you want to access the boot selector, let push start or select on boot :
select will boot on smc's parameter (boot.ini made with gpbootconf) (and load the background)
start will boot on eprom's parameter (faster!! but no background and no smc progs in the boot selector...

to run directly a firmware (the fastest way to do it), let push on boot :
Front right : Pacrom
Front left : fw euro
Left : Yafl/Wind-ups

If you launch directly a firmware from the boot selector, it's pclink will probably not work correctly.. (if you flash your gp32 with it after, it will work correctly).

If you want to protect your gp32 with a password, use password.fxe to enable it. You cannt change the password for security reasons, it's always :
B, front Left, A, right

--- How to flash your gp32 ---

1 : Put fw.fxe in the gp:\gpmm directory
2 : Rename aqua48.bin into fw.bin then put it in the gp:\ directory
3 : Put fresh batteries on your gp32
4 : Launch fw.fxe, just don't turn your gp32 off during the flashing...

--- ---------------------- ---

that is what is said in READ ME

 

[damaki]

Until that, all goes perfectly but when I reset GP32, it asks me for a password, I put AAAA, but it sais, that´s incorrect.
What can I do if I´m doing all all right??
Bye

​

If you want to protect your gp32 with a password, use password.fxe to enable it. You cannt change the password for security reasons, it's always :
B, front Left, A, right

...

 

[aapje89]

So try: B, front Left, A, right

 

[osy_tnt91]

yes, that was all, because of problems, I almost became crazy!!!!!!!!!

 

[Quiest]

Does it has any benefits to upgrade?
I am really happy with my old aquafish fw and I run wind-ups everytime, and everything works fine.