pandora 1ghz don t start

[laurent0977]

Hi


I have buy a pandora pcb 1 ghz but i have problem with


Pcb 1 ghz dont start


I have problem with connector lcd. The close connector is out of his emplacement


But the pcb dont run no led red or green nothing


Have you the same problem ?


Can you help me ?


Thanks


Lolo

 

[Linux-SWAT]

You also have a battery right ?

 

[CocoCreekFisherman]

h34r:  Are you sure the battery is seated inside properly? Does it charge with the adaptor?

 

[laurent0977]

Not battery dont charge

In fact openpandora dont start with charger or sector

Nothing pandora is black dont start no led nothing

I have replacement battery with other nothing

If lcd cable or connector is damaged pandora led must start i think ?

Thanks

 

[TrashyMG]

Try keeping the Pandora on the charger for an Hour even if you don't see any lights. If the Battery is completely drained it may take a while for it to have enough to power up. Don't use USB for charging, use the AC charger.

 

[laurent0977]

I have a black battery i think battery green is tje same thing ?

I charged battery during 7 hours and nothing

 

[TrashyMG]

Are the Battery contacts touching properly? 

Did you get this new or off Ebay or personal sale?

 

[laurent0977]

Maybe i have a problem with hardware ?

I try change my pcb cart alone i m very idiot

I have send complete console at evil dragon

Thanks for your help

Lolo

 

[TrashyMG]

Oh so you swapped out the PCB for a 1ghz PCB.. yeah it's possible if the LCD cable isn't in right it could be shorting something. 

 

[laurent0977]

Maybe connector battery not touching battery i have try with carton but nothing

I think connector battery is a good idea i have try

You have a other idea for connector battery ?

 

[CocoCreekFisherman]

Are the Battery contacts touching properly? 


Did you get this new or off Ebay or personal sale?

Was it bought on ebay??

 

[laurent0977]

Yes the clip connector lcd is not here. With nor cable lcd pandora dont start ?

Lolo

 

[laurent0977]

Not i have buy at evil dragon but i have break clip connector i have very idiot

I have change alone lcd cable 600 mh and after run good

But with 1 ghz i have problem with clip connector lcd

I m sorry for me

Lolo

 

[Linux-SWAT]

The OP can start without a screen, so you should see the leds.

 

[laurent0977]

Not no led nothing nothing

Black is black

Pandora dont run

Not pcb not screen

Very thanks for your reply

 

[laurent0977]

Ah linux swat you are french me too

Lolo

 

[EvilDragon]

Did you break the black thing on the connector or lose it?

It's possible to fix it if it's not broken, if you're careful, and I still have enough of those lying around here.

In worst case, GC could also replace the full LCD connector.

 

[Linux-SWAT]

Je le parler un peu le français comme toi le anglais.

 

[laurent0977]

Yes it s a black connector on lcd. I have black connector alone

Do you think its the lcd cable damage or conector ?

Lolo

I m sorry evil

 

[laurent0977]

If the connector lcd is damaged, Led pandora dont run ?

Lolo