Black Log-in Screen

[sanctuary13]

I was attempting to update my FW from 2.0 to 3.0.

First I flashed to the 2.1, and that went fine. Then I flashed to 3.0, and now all hell has broken loose. It said the update was complete too.

I get the initial black login screen with the little melody, then it goes to the green loading screen, says "v2.0.0" at the bottom, stays there for a few seconds, then goes to a black screen. then absolutely NOTHING. i tried reflashing, debricking, used the guide, going back to 1.0.1, NOTHING. it comes on, chimes, loads, then black.

help me out here.

 

[Squidge]

If it says 2.0.0 at the bottom, then you didn't update properly or you have bad nand. Have you tried to go back to 2.1? 3.0 really doesn't offer anything extra.

 

[Eclipse]

if it loads it's a good signal, don't despair... can you use a serial cable to read the log infos during the boot?

also, 3.0 is the lamerest one... 4.0 offers SDHC compatibility and you can update to it directly from the 2.1.x one

 

[sanctuary13]

i dont have a serial cable, and everytime i try to flash with 2.0 or 2.1 it just goes to black screen after the load screen.

 

[sanctuary13]

kk, reformatted the SD card and managed to get 2.0 back on, yay!
now im tryin out 4.0

i was kinda hopin it was bricked so i could go buy a F200