Search results

  1. V

    GP32 Eint[2] Line

    Hi, I have actually disassemble the SWI 0x7 function of the GP32 firmware ... this function just initialize the I/O port lines of the processor, but I found that the line number 2 of the port E is configured to be the EINT[2] line and would like to know where can be found this wire (on the EXT...
  2. V

    Gp32 Titles In Spain

    Hi, I am curious which commercial games have been released for the GP32 BLU in Spain ... browsing the virgingplay website does not give any list of games released for this event, and also would like to know at what price they are sold for ? I have seen a picture of Her Knight in one of the...
  3. V

    GP32 Questions Re. Clocks

    Hi, I am currently designing some functions to set the clock registers of the GP32. When reading the Samsung Arm920T manual, I see that there is a limit for HCLK and PCLK of 66MHz, which in fact limit also FCLK (due to the fact that FCLK is used as a master clock for HCLK and PCLK) to 132MHz...
  4. V

    GP32 Arm Mode Questions

    Hi, I experimented last night re. the different ARM modes (especially the User, System and Supervisor). I have noticed that GP32 gives Supervisor mode when entering any FXEs (I guess the same for GXEs), and then if you switch to user/system mode, setting a good stack pointer, then a lot of SWIs...
  5. V

    GP32 Adresses Mistery

    Hi, I have a list of addresses that I would like if someone have any clues about (apart the fact these are addresses pointed to some system areas), returned by the function num. 3 of the SWI 0xb : 0x0c7ab800 ; 0x0c7ab840 ; 0x0c7ab878 ; 0x0c7ab8b0 ; 0x0c7ab8dc ; 0x0c7ab914 ; 0x0c7ab938...
  6. V

    GP32 Envid Bit In Lcdcon1 Problem

    Hi all, I am confronted against a problem on GP32 when trying to disable and enable the video output through the ENVID bit of the LCDCON1 register. When setting the bit to 0, the output is disabled, and apparently it is working (the screen is like frozen, which is normal), but when putting back...
Back
Top