On 08/06/15 10:55, Dr. H. Nikolaus Schaller wrote:
Hi Tomi, finally we have managed to get the ssd2858 rotator chip + panel running - except one issue.
We see some tearing because the SSD / panel runs at a slightly different VSYNC rate than the OMAP5.
We now have enabled a TE impulse from the ssd2858 chip going to dsiporta_te0 / gpio6_189.
The question is how to enable it on the OMAP5 side.
I presume you are using the SSD2858 with DSI video mode input. There's no TE in that case. TE is only for DSI command mode.
Tomi