This patch set provides several improvements for the CI20 board:
* suppress warnings from i2c if device is not responding * make ingenic-drm found through DT * allow davicom dm9000 ethernet controller to use MAC address provided by U-Boot * fix #include in jz4780.dtsi * configure for loadable kernel modules * add DTS for IR sensor and SW1 button * configure so that LEDs, IR sensor, SW1 button have drivers * fix DTS for ACT8600 PMU and configure driver * fix interrupt of nxp,pcf8563
There is another patch set in our queue to add HDMI support on top of this work.
Signed-off-by: Paul Boddie paul@boddie.org.uk Signed-off-by: H. Nikolaus Schaller hns@goldelico.com
Alex Smith (1): MIPS: DTS: CI20: add DT node for IR sensor
H. Nikolaus Schaller (13): i2c: jz4780: suppress txabrt reports for i2cdetect drm: ingenic-drm: add MODULE_DEVICE_TABLE net: davicom: dm9000: allow to pass MAC address through mac_addr module parameter MIPS: DTS: jz4780: fix #includes for irq.h and gpio.h MIPS: CI20: defconfig: configure for supporting modules MIPS: CI20: defconfig: compile leds-gpio driver into the kernel and configure for LED triggers MIPS: DTS: CI20: fix PMU definitions for ACT8600 MIPS: CI20: defconfig: configure CONFIG_REGULATOR_ACT8865 for PMU MIPS: DTS: CI20: give eth0_power a defined voltage. MIPS: CI20: defconfig: compile gpio-ir driver MIPS: DTS: CI20: add DT node for SW1 as Enter button MIPS: CI20: defconfig: configure for CONFIG_KEYBOARD_GPIO=m MIPS: DTS: CI20: fix interrupt for pcf8563 RTC
arch/mips/boot/dts/ingenic/ci20.dts | 71 ++++++++++++++++++++------ arch/mips/boot/dts/ingenic/jz4780.dtsi | 2 + arch/mips/configs/ci20_defconfig | 21 ++++++++ drivers/gpu/drm/ingenic/ingenic-drm.c | 2 + drivers/i2c/busses/i2c-jz4780.c | 3 ++ drivers/net/ethernet/davicom/dm9000.c | 42 +++++++++++++++ 6 files changed, 125 insertions(+), 16 deletions(-)