It is not completely obvious that these are required as some .dts files don't specify them.
Signed-off-by: H. Nikolaus Schaller hns@goldelico.com --- .../devicetree/bindings/gpio/gpio-pca953x.txt | 33 ++++++++++++++++++++++ 1 file changed, 33 insertions(+)
diff --git a/Documentation/devicetree/bindings/gpio/gpio-pca953x.txt b/Documentation/devicetree/bindings/gpio/gpio-pca953x.txt index 6a7cddb187c1..7f3b50a6d681 100644 --- a/Documentation/devicetree/bindings/gpio/gpio-pca953x.txt +++ b/Documentation/devicetree/bindings/gpio/gpio-pca953x.txt @@ -36,6 +36,10 @@ Optional properties: - reset-gpios: GPIO specification for the RESET input. This is an active low signal to the PCA953x. - vcc-supply: power supply regulator. + - gpio-controller: if used as gpio expander. + - #gpio-cells: if used as gpio expander. + - interrupt-controller: if to be used as interrupt expander. + - #interrupt-cells: if to be used as interrupt expander.
Example:
@@ -48,3 +52,32 @@ Example: interrupt-parent = <&gpio3>; interrupts = <23 IRQ_TYPE_LEVEL_LOW>; }; + + +Example with Interrupts: + + + gpio99: tca6424@22 { + compatible = "nxp,pcal6524"; + reg = <0x22>; + interrupt-parent = <&gpio6>; + interrupts = <1 IRQ_TYPE_EDGE_FALLING>; /* gpio6_161 */ + interrupt-controller; + #interrupt-cells = <2>; + vcc-supply = <&vdds_1v8_main>; + gpio-controller; + #gpio-cells = <2>; + gpio-line-names = + "hdmi-ct-hpd", "hdmi.ls-oe", "p02", "p03", "vibra", "fault2", "p06", "p07", + "en-usb", "en-host1", "en-host2", "chg-int", "p14", "p15", "mic-int", "en-modem", + "shdn-hs-amp", "chg-status+red", "green", "blue", "en-esata", "fault1", "p26", "p27"; + }; + + ts3a227@3b { + compatible = "ti,ts3a227e"; + reg = <0x3b>; + interrupt-parent = <&gpio99>; + interrupts = <14 IRQ_TYPE_EDGE_RISING>; + ti,micbias = <0>; /* 2.1V */ + }; +