Hi,

1.
Did not notice that any key is not working

2.
I suppose heavy flickering means I can't miss it if I watch my unit
booting up.
Never noticed anything like that.

3.
Entering suspend mode does not work AFAIR.
But leaving my alone for a while does not do any harm.
The screen will go blank and I automatically log out.
When I press any  button I'm back in the OS and can log in.

I'm using an older version of the OS. I might do a fresh reinstall for
the Gamescom after my exams.
Maybe it's an issue with a more recent firmware.
I'm also using aTcs firmware.

Best regards
Nino

On 03.07.2018 11:49, Michael Mrozek wrote:
> Hi,
>
> just a few quick questions to everyone who has a prototype. Before I
> file a bug, I wanted to check if others can confirm this as well.
>
> I'm using aTc's OS.
>
> 1. . - Key (the left one on the lower row) is not working. Happens with
> multiple Mainboards - keymat looks fine (but I haven't changed it yet).
> Softwarebug?
>
> 2. Sometimes, I encounter heavy flickering of the LCD. Especially
> shortly after boot up. This looks like displays backlight power
> completely breaks down.
> @Nikolaus: Is there a test point where I can measure the power that
> arrives at the display board?
> Or is this a software bug?
>
> 3. As soon as the Pyra enters a bit of powersaving mode (switching off
> the backlight of the LCD), it freezes. Not sure if it only blanks the
> display or does something else, but it looks like something freezes
> when entering a low-power state.
>

_______________________________________________
Kernel mailing list
Kernel@pyra-handheld.com
http://pyra-handheld.com/cgi-bin/mailman/listinfo/kernel