packing of 1Ghz units in the wooden box was reported to be somewhat sloppy (pardon my straightforwardness).
what seems to be the problem: not enough padding in the box, so the different parts inside are at risk to damage each other during transportation.
possible solution: add more padding (bubble wrap, old newspaper, whatever) into the box to make sure the parts inside dont move.
so far youve been asked a couple of times but didnt provide proper info on this subject. how exactly are you going to address this issue?
did packing procedures change by now? are you even thinking about changing anything?
what seems to be the problem: not enough padding in the box, so the different parts inside are at risk to damage each other during transportation.
possible solution: add more padding (bubble wrap, old newspaper, whatever) into the box to make sure the parts inside dont move.
so far youve been asked a couple of times but didnt provide proper info on this subject. how exactly are you going to address this issue?
did packing procedures change by now? are you even thinking about changing anything?